A sensitive and specific HPLC-MS method for the determination of sophoridine,sophocarpine and matrine in rabbit plasma

A sensitive and specific method was developed for the determination of sophoridine (SRI), sophocarpine (SC) and matrine (MT) in rabbit plasma by HPLC-MS. After an administration of Kuhuang by injection, blood samples were collected and extracted with methanol. The extract solutions were analysed by HPLC-MS method. The separation was performed on a ZORBAX Extend-C18 column using methanol/water/diethylamine (50:50:0.07, v/v/v) as mobile phase. The quinolizidine alkaloids were detected by using mass spectrometry in the SIM mode. There was a good linear relationship between peak area and concentration of analytes over the concentration range of 13.2–995.0 ng mL^–1 for SRI, 7.0–530.0 ng mL^–1 for SC and 8.8–655.0 ng mL^–1 for MT, respectively. The absolute recovery of this method was more than 57% for SRI, 87% for SC and 91% for MT. The accuracy of assay was more than 90%. The limits of detection (LODs) were 6.8 ng mL^–1 for SRI, 3.5 ng mL^–1 for SC and 4.2 ng mL^–1 for MT, respectively. The limits of quantitation (LOQs) were 13.2 ng mL^–1 for SRI, 7.0 ng mL^–1 for SC and 8.8 ng mL^–1 for MT, respectively. The intra-day and inter-day coefficients of variation (RSDs) were less than 10.1, 6.3 and 5.8% for SRI, SC and MT, respectively. The developed method was applied to determine the concentration–time profiles of SRI, SC and MT in rabbit plasma after injection of Kuhuang.     

Solubility of Solid 2-Methyl-1,3-butadiene (Isoprene) in Liquid Argon and Nitrogen at the Standard Boiling Points of the Solvents

The solubility of solid 2-methyl-1,3-butadiene (isoprene) in liquid argon at a temperature of 87.3 K and in liquid nitrogen at 77.4 K has been measured by the filtration method. The hydrocarbon contents in solutions were determined using gas chromatography. GC–MS was used to identify impurities in the solute. The experimental value of the mole fraction solubility of solid isoprene in liquid argon at 87.3 K is (1.41 ± 0.27) × 10^–6 and (1.56 ± 0.36) × 10^–7 in liquid nitrogen at 77.4 K. The Preston–Prausnitz method was used for calculation of the solubilities of solid hydrocarbon in liquid argon in the temperature range 84.0–110.0 K and in liquid nitrogen from 64.0 to 90.0 K. The solvent–solute interaction parameters l ₁₂ were also calculated. At 90.0 K liquid argon is a better solvent for isoprene than is liquid nitrogen. The experimental values of the solubilities of isoprene in liquid argon and nitrogen were compared with results obtained for selected unsaturated and aromatic hydrocarbons.     

Solubility of Solid 2,3-Dimethylbutane and Cyclopentane in Liquid Argon and Nitrogen at the Standard Boiling Points of the Solvents

The solubilities of solid 2,3-dimethylbutane and cyclopentene in liquid argon at a temperature of 87.3 K and in liquid nitrogen at 77.4 K have been measured by the filtration method. The hydrocarbon contents in solutions were determined using gas chromatography. GC–MS was used to identify impurities in solutes. The experimental value of the mole fraction solubility of solid 2,3-dimethyl-butane in liquid argon at 87.3 K is (8.26 ± 1.60) × 10^–6 and (2.77 ± 0.94) × 10^–8 in liquid nitrogen at 77.4 K. The experimental value of the mole fraction solubility of solid cyclopentene in liquid argon at 87.3 K is (5.11 ± 0.44) × 10^–6 and (4.60 ± 0.76) × 10^–8 in liquid nitrogen at 77.4 K. The Preston–Prausnitz method was used for calculation of the solubilities of solid hydrocarbons in liquid argon in the temperature range 84.0–110.0 K and in liquid nitrogen from 64.0 to 90.0 K. The solvent–solute interaction parameters l ₁₂ were also calculated. At 90.0 K liquid argon is a better solvent for investigated solid hydrocarbons than is liquid nitrogen.     

Kinetics of electrode reaction coupled to ion transfer across the liquid/liquid interface

In the theoretical model it is assumed that a graphite disk electrode is covered by a thin film of solution of decamethylferrocene (dmfc) and some electrolyte CX in nitrobenzene and immersed in an aqueous solution of the electrolyte MX. Oxidation of dmfc is accompanied by the transfer of anion X ⁻ from water into nitrobenzene since it is also assumed that cations dmfc ⁺ and C ⁺ are insoluble in water and cation M ⁺ is insoluble in nitrobenzene. Kinetic parameters of the electrode reaction can be determined if the total potential difference across the nitrobenzene/water interface is maintained constant by adding the electrolytes CX and MX in concentrations which are much higher than the initial concentration of dmfc in nitrobenzene.     

Application of ultrasound-assisted acid leaching procedures for major and trace elements determination in edible seaweed by inductively coupled plasma-optical emission spectrometry

A new method using diluted reagents (nitric and hydrochloric acids and oxygen peroxide) and ultrasound energy to assist metals acid leaching with from edible seaweed was optimized. The method uses a first sonication at high temperature with hydrochloric acid as a previous stage to an ultrasound-assisted acid leaching with 7 ml of an acid solution containing nitric acid, hydrochloric acid and hydrogen peroxide at concentrations of 3.7, 3.0 and 3.0 M, respectively. Optimum conditions for the first sonication step were ultrasound energy at 17 kHz, sonication temperature at 65 °C, an acid volume of 2 ml, an hydrochloric acid concentration of 6.0 M and a sonication time of 10 min. It has been found that the first sonication stage at high temperature with hydrochloric acid is necessary to obtain quantitative recoveries for As, Ba, Fe and V. Otherwise quantitative recoveries were reached for the other elements investigated (Ca, K, Na, Mg, Cd, Cr, Cu, Mn, Ni, Pb and Zn). The repeatability of the ultrasound-assisted acid leaching method was around 10% for all elements. Adequate limit of detection and limit of quantification were reached by using inductively coupled plasma-optical emission spectrometry (ICP-OES) for measurements. The method resulted accurate after analysing several seaweed certified reference materials (IAEA-140/TM, NIES-03 and NIES-09). The method was finally applied to the multi-element determination in edible seaweed samples.     

Surfactant in the gaseous phase II. Influence on stability of foams and thin liquid films

The influence of the vapors ofn-amyl orn-decyl alcohol on the stability of single thin liquid films, single bubbles, and foam columns was determined. It was found that the presence of surfactant vapors lowered the stability of foams and single foam films. The mechanism of the destabilizing action of the surfactant vapors on wet, dynamic foams under dynamic conditions is discussed. It is shown that the destabilizing action of the surfactant vapors is a further indication that surface elasticity forces are the main factor determining stability of wet, dynamic foams.     

Indirect detection in reversed-phase liquid chromatography: Ion-pair retention models for cations on polystyrene polymers

Summary The distribution equilibria of cationic compounds in reversed-phase chromatographic systems (ion-pair chromatography) have been studied on the basis of their effect on a detectable mobile phase component. The solid phase was a polystyrene-divinylbenzene copolymer and the detectable component, a quaternary ammonium ion, 1-methylpyridine. The solutes were mono- and divalent amines and quaternary ammonium ions. The cations can be retained by ion-pair adsorption and ion exchange. Expressions for the ion-pair retention of the solutes and the mobile phase cation (system peak) have been developed assuming Langmuir distribution of ion pairs to a solid phase with one kind of binding site. The validity of the expressions has been tested by evaluation of ion-pair distribution constants using non-linear curve fitting techniques. Good agreement for the constants of common ion pairs was obtained from different kinds of capacity ratio expressions. Ion exchange retention can appear beside ion-pair retention, and it has been observed in the pH range 1.6–6.1. The effect depends not only on cations in the mobile phase, but also on the nature of the buffering systems.     

The effect of alcoholic mobile phase modifiers on retention and stereoselectivity on a commercially available cellulose-based HPLC chiral stationary phase: An unexpected reversal in enantiometric elution order

Summary High pressure liquid chromatographic methods for the determination of diphenylmethane-4,4-diisocyanate (MDI) and toluene diisocyanate (TDI) in chemical products are described. The MDI- and TDI monomers were determined as their urea derivative formed by the reaction with 9-(methyl aminomethyl)-anthracene. Using these methods MDI- and TDI monomer concentrations have been determined in 55 chemical products: sealing waxes, insulating- and adhesive foam, hardener, primer, adhesives and surface coatings. The recovery of both MDI and TDI monomers from various types of chemical product was found to be 92–97%, and the relative standard deviations of the methods was <5% for all types of products.     

含VE微胶囊的制备及其控制释放性能研究

以天然维生素E（VE）为芯材，利用Shirasu porous glass (SPG) 膜乳化结合液中干燥法，制备了粒径单分散的聚苯乙烯（PS）微胶囊.微胶囊的粒径为膜孔径的4倍，粒径单分散系数CV小于0.2.考察了改变PS和VE的比例及微胶囊的粒径对控制释放性能的影响.     

Pressurized liquid extracts from Spirulina platensis microalga. Determination of their antioxidant activity and preliminary analysis by micellar electrokinetic chromatography

In this work, different extracts from the microalga Spirulina platensis are obtained using pressurized liquid extraction (PLE) and four different solvents (hexane, light petroleum, ethanol and water). Different extraction temperatures (115 and 170 degrees C) were tested using extraction times ranging from 9 to 15 min. The antioxidant activity of the different extracts is determined by means of an in vitro assay using a free radical method. Moreover, a new and fast method is developed using micellar electrokinetic chromatography with diode array detection (MEKC-DAD) to provide a preliminary analysis on the composition of the extracts. This combined application (i.e., in vitro assays plus MEKC-DAD) allowed the fast characterization of the extracts based on their antioxidant activity and the UV-vis spectra of the different compounds found in the extracts. To our knowledge, this work shows for the first time the great possibilities of the combined use of PLE-in vitro assay-MEKC-DAD to investigate natural sources of antioxidants.